bomo
10-14-2007, 11:33 PM
bonjour et merci ŕ tous je crois j'ai presque fini mon installation mais au fait j'ai un derneier souci rien ne s'affiche et voici mes resultats
Nagios 2.9
Copyright (c) 1999-2007 Ethan Galstad (http://www.nagios.org)
Last Modified: 04-10-2007
License: GPL
Reading configuration data...
Running pre-flight check on configuration data...
Checking services...
Warning: Service 'PING' on host 'ROUTEUR_POWERLINE' has a notification interval less than its check interval! Notifications are only re-sent after checks are made, so the effective notification interval will be that of the check interval.
Checked 1 services.
Checking hosts...
Checked 1 hosts.
Checking host groups...
Checked 1 host groups.
Checking service groups...
Checked 0 service groups.
Checking contacts...
Checked 1 contacts.
Checking contact groups...
Checked 1 contact groups.
Checking service escalations...
Checked 0 service escalations.
Checking service dependencies...
Checked 0 service dependencies.
Checking host escalations...
Checked 0 host escalations.
Checking host dependencies...
Checked 0 host dependencies.
Checking commands...
Checked 47 commands.
Checking time periods...
Checked 5 time periods.
Checking extended host info definitions...
Checked 1 extended host info definitions.
Checking extended service info definitions...
Checked 1 extended service info definitions.
Checking for circular paths between hosts...
Checking for circular host and service dependencies...
Checking global event handlers...
Checking obsessive compulsive processor commands...
Checking misc settings...
Total Warnings: 1
Total Errors: 0
Things look okay - No serious problems were detected during the pre-flight check
Nagios 2.9
Copyright (c) 1999-2007 Ethan Galstad (http://www.nagios.org)
Last Modified: 04-10-2007
License: GPL
Warning: Service 'PING' on host 'ROUTEUR_POWERLINE' has a notification interval less than its check interval! Notifications are only re-sent after checks are made, so the effective notification interval will be that of the check interval.
Projected scheduling information for host and service
checks is listed below. This information assumes that
you are going to start running Nagios with your current
config files.
HOST SCHEDULING INFORMATION
---------------------------
Total hosts: 1
Total scheduled hosts: 1
Host inter-check delay method: SMART
Average host check interval: 60.00 sec
Host inter-check delay: 60.00 sec
Max host check spread: 30 min
First scheduled check: Sun Oct 14 20:30:53 2007
Last scheduled check: Sun Oct 14 20:30:53 2007
SERVICE SCHEDULING INFORMATION
-------------------------------
Total services: 1
Total scheduled services: 1
Service inter-check delay method: SMART
Average service check interval: 120.00 sec
Inter-check delay: 120.00 sec
Interleave factor method: SMART
Average services per host: 1.00
Service interleave factor: 1
Max service check spread: 30 min
First scheduled check: Sun Oct 14 20:32:53 2007
Last scheduled check: Sun Oct 14 20:32:53 2007
CHECK PROCESSING INFORMATION
----------------------------
Service check reaper interval: 10 sec
Max concurrent service checks: 20
PERFORMANCE SUGGESTIONS
-----------------------
I have no suggestions - things look okay.
cgi.cfg - déplacement OK
checkcommands.cfg - déplacement OK
contactgroups.cfg - déplacement OK
contacts.cfg - déplacement OK
dependencies.cfg - déplacement OK
escalations.cfg - déplacement OK
hostextinfo.cfg - déplacement OK
hostgroups.cfg - déplacement OK
hosts.cfg - déplacement OK
meta_commands.cfg - déplacement OK
meta_contact.cfg - déplacement OK
meta_contactgroup.cfg - déplacement OK
meta_dependencies.cfg - déplacement OK
meta_escalations.cfg - déplacement OK
meta_host.cfg - déplacement OK
meta_hostgroup.cfg - déplacement OK
meta_services.cfg - déplacement OK
meta_timeperiod.cfg - déplacement OK
misccommands.cfg - déplacement OK
nagios.cfg - déplacement OK
perfparse.cfg - déplacement OK
resource.cfg - déplacement OK
serviceextinfo.cfg - déplacement OK
servicegroups.cfg - déplacement OK
services.cfg - déplacement OK
timeperiods.cfg - déplacement OK
/etc/init.d/ods start
Starting ODS Collector : ods
et apres quelque temps on me mets quand je relance Error : /usr/local/oreon/ODS/var/ods.pid already Exists.
pouvez m'expliquer ces differents problemes merci
Nagios 2.9
Copyright (c) 1999-2007 Ethan Galstad (http://www.nagios.org)
Last Modified: 04-10-2007
License: GPL
Reading configuration data...
Running pre-flight check on configuration data...
Checking services...
Warning: Service 'PING' on host 'ROUTEUR_POWERLINE' has a notification interval less than its check interval! Notifications are only re-sent after checks are made, so the effective notification interval will be that of the check interval.
Checked 1 services.
Checking hosts...
Checked 1 hosts.
Checking host groups...
Checked 1 host groups.
Checking service groups...
Checked 0 service groups.
Checking contacts...
Checked 1 contacts.
Checking contact groups...
Checked 1 contact groups.
Checking service escalations...
Checked 0 service escalations.
Checking service dependencies...
Checked 0 service dependencies.
Checking host escalations...
Checked 0 host escalations.
Checking host dependencies...
Checked 0 host dependencies.
Checking commands...
Checked 47 commands.
Checking time periods...
Checked 5 time periods.
Checking extended host info definitions...
Checked 1 extended host info definitions.
Checking extended service info definitions...
Checked 1 extended service info definitions.
Checking for circular paths between hosts...
Checking for circular host and service dependencies...
Checking global event handlers...
Checking obsessive compulsive processor commands...
Checking misc settings...
Total Warnings: 1
Total Errors: 0
Things look okay - No serious problems were detected during the pre-flight check
Nagios 2.9
Copyright (c) 1999-2007 Ethan Galstad (http://www.nagios.org)
Last Modified: 04-10-2007
License: GPL
Warning: Service 'PING' on host 'ROUTEUR_POWERLINE' has a notification interval less than its check interval! Notifications are only re-sent after checks are made, so the effective notification interval will be that of the check interval.
Projected scheduling information for host and service
checks is listed below. This information assumes that
you are going to start running Nagios with your current
config files.
HOST SCHEDULING INFORMATION
---------------------------
Total hosts: 1
Total scheduled hosts: 1
Host inter-check delay method: SMART
Average host check interval: 60.00 sec
Host inter-check delay: 60.00 sec
Max host check spread: 30 min
First scheduled check: Sun Oct 14 20:30:53 2007
Last scheduled check: Sun Oct 14 20:30:53 2007
SERVICE SCHEDULING INFORMATION
-------------------------------
Total services: 1
Total scheduled services: 1
Service inter-check delay method: SMART
Average service check interval: 120.00 sec
Inter-check delay: 120.00 sec
Interleave factor method: SMART
Average services per host: 1.00
Service interleave factor: 1
Max service check spread: 30 min
First scheduled check: Sun Oct 14 20:32:53 2007
Last scheduled check: Sun Oct 14 20:32:53 2007
CHECK PROCESSING INFORMATION
----------------------------
Service check reaper interval: 10 sec
Max concurrent service checks: 20
PERFORMANCE SUGGESTIONS
-----------------------
I have no suggestions - things look okay.
cgi.cfg - déplacement OK
checkcommands.cfg - déplacement OK
contactgroups.cfg - déplacement OK
contacts.cfg - déplacement OK
dependencies.cfg - déplacement OK
escalations.cfg - déplacement OK
hostextinfo.cfg - déplacement OK
hostgroups.cfg - déplacement OK
hosts.cfg - déplacement OK
meta_commands.cfg - déplacement OK
meta_contact.cfg - déplacement OK
meta_contactgroup.cfg - déplacement OK
meta_dependencies.cfg - déplacement OK
meta_escalations.cfg - déplacement OK
meta_host.cfg - déplacement OK
meta_hostgroup.cfg - déplacement OK
meta_services.cfg - déplacement OK
meta_timeperiod.cfg - déplacement OK
misccommands.cfg - déplacement OK
nagios.cfg - déplacement OK
perfparse.cfg - déplacement OK
resource.cfg - déplacement OK
serviceextinfo.cfg - déplacement OK
servicegroups.cfg - déplacement OK
services.cfg - déplacement OK
timeperiods.cfg - déplacement OK
/etc/init.d/ods start
Starting ODS Collector : ods
et apres quelque temps on me mets quand je relance Error : /usr/local/oreon/ODS/var/ods.pid already Exists.
pouvez m'expliquer ces differents problemes merci