No configuration possible on Webpage

[Sven]

Hi,

I installed Centreon 2 RC5 on my Opensuse 10.3 together with Nagios 3 and the NDO stuff following the steps proposed in Wiki. After I was able to login to centreon, I could not configure anything at all. No matter which link I follow, I'll always just get the menu structures, but not real content.
http://img389.imageshack.us/img389/4681/centreonyd0.th.jpg (http://img389.imageshack.us/my.php?image=centreonyd0.jpg)
The only pages that contain any content are Sessions, Server Status, Database and about in the Administration menu.
I did not install centreon to the default location, except the /etc/centreon (which is symlinked).
Centreon recognizes nagios, I guess since I've just set it up with localhost and a few (8) services that are also shown in the above image.

Any hints what I'm doing wrong?

tia,

Sven

[mcazemier]

Check the rights of your nagios cfg folders.
Follow the wikis from centreon: http://en.doc.centreon.com/Setup

[Sven]

I did so, additionally I've set the rights of nagios config folder to 777 just to be sure that it's working. Shouldn't I be able to set up Access Groups? I mean, I can't see anything on any page except the few I mentioned on in my last post.

Is there some debugging mode to switch centreon to, maybe this would give me some hint?

regards,

Sven

[Sven]

I found the problem. My PEAR installation was somehow messed up and therefore nothing worked. The Webfrontend told that everything was fine ... This (http://forum.centreon.com/showpost.php?p=40804) post should be linked in the wiki, because people that are not so familiar with php/perl definitaly need that hint if they are behind a proxy.